We will notify you by email when the product is available again!
Questions?
Connects2 CAM-FD10 Reversing Camera
This vehicle-specific reversing camera is installed in place of the car's original third brake light. The camera has IP69K protection, meaning it is completely dustproof and resistant to high-pressure water jets. Infrared LEDs enable imaging even in complete darkness (0 lux).
The camera has a fixed 35 cm cable with a multi-pin connector. A 10 m extension cable is included to connect the camera to, for example, an Alpine head unit or a separate display.
Compatibility
- Ford Transit Custom 2016–2021 (vans with barn doors)
Technical Specifications
- Type: reversing camera with third brake light
- Viewing angle: 120°
- Sensor: 1/3″ CMOS
- IP rating: IP69K
- Image type: PAL
- Infrared LEDs: yes
- Minimum illumination: 0 lux
- Resolution: 500 × 582
- Operating voltage: 12 V
- Fixed cable: 35 cm, with multi-pin connector
- Included: 10 m extension cable
Installation
- Remove the car's original third brake light and disconnect its cable.
- Connect the cable to the CAM-FD10 camera and test the brake light function.
- Connect the included extension cable to the camera's fixed cable and install the camera in the place of the original brake light. Ensure that no wires are bent or pinched.
- Black wire = ground
- Red wire = power from the reversing light
- Yellow RCA cable = to the head unit/display's reversing camera input. If an Alpine head unit with a Direct camera input is used, the Alpine AH-CAMA-ALP1 adapter is required.